Hi,
I (client side) am simulating a MODEM using TCP/IP protocol.
Is there any way to monitor and control the MODEM lines as shown in the figure attached.
See the control lines of the Server MODEM:
MODEM Simulation
Started by
Runjhun
, Aug 07 2012 10:47 AM
5 replies to this topic
#1
Posted 07 August 2012 - 10:47 AM
#3
Posted 07 August 2012 - 02:45 PM
A positive attitude may not solve all your problems, but it will annoy enough people to make it worth the effort. (Herm Albright 1876-1944).
Founder and general mischief maker on www.labview-tools.com.
SQlite aficionado and websocket zealot.
If it 'aint in LabVIEW, then you 'aint got a clue!
Founder and general mischief maker on www.labview-tools.com.
SQlite aficionado and websocket zealot.
If it 'aint in LabVIEW, then you 'aint got a clue!
#4
Posted 08 August 2012 - 11:22 AM
As I mentioned am using TCP/IP protocol.
Will VISA properties accessible through TCP/IP ?
Will VISA properties accessible through TCP/IP ?
#5
Posted 08 August 2012 - 11:45 AM
TCP/IP is not a serial interface. It does not use the same flow control standards.
Now is the right time to use %^<%Y-%m-%dT%H:%M:%S%3uZ>T
#6
Posted 08 August 2012 - 12:52 PM
No. As Phillip states. It is not a modem and therefore does not use Modem hardware signalling.
A positive attitude may not solve all your problems, but it will annoy enough people to make it worth the effort. (Herm Albright 1876-1944).
Founder and general mischief maker on www.labview-tools.com.
SQlite aficionado and websocket zealot.
If it 'aint in LabVIEW, then you 'aint got a clue!
Founder and general mischief maker on www.labview-tools.com.
SQlite aficionado and websocket zealot.
If it 'aint in LabVIEW, then you 'aint got a clue!














