Jump to content

Error Cluster color


Recommended Posts

Is there a way to change the color of the error cluster wires (or any cluster wires for that matter) on the block diagram? I have seen images posted that have green error cluster wires.

Example:

post-1591-1143677727.png?width=400

Put the following line into labview.ini

funkyerrClustWire=True

It works in LV7.0, I don't know about LV8, since I don't use it (yet).

Link to comment
Put the following line into labview.ini

funkyerrClustWire=True

It works in LV7.0, I don't know about LV8, since I don't use it (yet).

I tried it in LV8.0.1. It works, but now all my VIs that use error wires are difficult to open until I manage to save them again. The difficulty: "This VI was changed on disk since last opened by LabVIEW. Revert?" followed by "Discard changes?". Clicking cancel in either dialog results in the VI not being opened. In some cases it's a pretty strange succession of those two boxes until somehow it all opens.

Edit: Rebooting the computer seems to have fixed this. Not that it makes sense.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.