Changing increment steps

[bjarket]

I would like to change the increment steps in a slide from 1's to 0.1's.

The NI homepage describes a solution for LV 8.2, but it doesn't seem to be applicable for LV 7.1, which I'm using.

http://zone.ni.com/reference/en-XX/help/37...crement_and_de/

Is there a solution for LV 7.1?

Thanks!

[Yair]

As far as I can tell, the only way to change the value in anything other than 1 is either using the shift key or using the up and down arrow keys on the keyboard. Using the increment\decrement buttons will not change the value by 0.1 even in 8.2 if I understand that correctly.

You can either use the arrow keys or create your own increment\decrement buttons which will change the value of the slide through local variables. Just be sure to look out for race conditions.

[jpdrolet]

QUOTE(bjarket @ Feb 26 2007, 11:01 AM)

I would like to change the increment steps in a slide from 1's to 0.1's.

The NI homepage describes a solution for LV 8.2, but it doesn't seem to be applicable for LV 7.1, which I'm using.

http://zone.ni.com/reference/en-XX/help/371361B-01/lvhowto/using_the_increment_and_de/' target="_blank">http://zone.ni.com/reference/en-XX/help/37...crement_and_de/

Is there a solution for LV 7.1?

Thanks!

On the Data Range properties tab of the control, unselect "Use Default Rang" and set Increment to 0.1

[bjarket]

QUOTE(jpdrolet @ Feb 26 2007, 10:09 PM)

On the Data Range properties tab of the control, unselect "Use Default Rang" and set Increment to 0.1

Just what I was looking for! Thanks!

[Yair]

QUOTE(jpdrolet @ Feb 26 2007, 11:09 PM)

On the Data Range properties tab of the control, unselect "Use Default Rang" and set Increment to 0.1

http://forums.lavag.org/index.php?act=attach&type=post&id=5049''>http://forums.lavag.org/index.php?act=attach&type=post&id=5049'>http://forums.lavag.org/index.php?act=attach&type=post&id=5049

It's always the little things that get you...