Jump to content

MBeckford

Members
  • Posts

    2
  • Joined

  • Last visited

    Never

Posts posted by MBeckford

  1. A set from a set of sampled data from a thickness sensor.

    The samples are stored in an appropriate array of up to 100 elements.

    The values represent the depth of the insulation around a particular cable.

    The thickness can vary from 0-4mm represented by a corresponding real value

    stored in the array. as long as the depth is between 1 and 4 mm the cable

    falls within the allowable specification however if it falls below 1mm it is

    deemed to be too thin.

    Design a VI that will identify the number of thin values and display as a

    percentage of total number of samples.

    The front panel have the must have the following:

    An array of controls holding the sampled values.

    An indicator holding the percentage of thin values.

    Labview version 8.2

  2. Hi Everyone,

    I am trying to create a vi, this vi will perfrom the following functions:

    1) Set the frequency (1Hz to 1KHz). Default 1 Hz

    2) Set the Phase Shift (-180degrees to 180degrees). Default 0degrees

    3) Set the Amplitude (0 to 20). Default 1

    4) Set the Offset (-5 to 5) Default 0

    5) Set the number of samples per cycle (20 to 1000). Default 100.

    6) Set the number of waves (1to 50) Default 1

    7) Set the start time t0 Default.

    I am new to Labview I have look at tutorials in creating a analogue waveform vi, but the Sinusodial is a bit more involved.

    Can you assist.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.