Hello,
I am fairly new to labview so forgive me for any rookie mistakes, i have managed to create a program where a user can press a button on the front panel and this will then operate a few stepper motors that are reliant on a dmm reading,
ok so here goes..... i have managed to get the program to initilaise my dmm and also to read and save a measurement from it, however i want the program to run in sequence i.e. activate the next stage after the measurement is complete that is why i have used seperate while loops.
i want the second while loop then to activate a motor which will turn and look for the highest peak on the dmm and once found will record that measurement.
i have tried searching but to no prevail so any help would be brilliant!!!!
cheers
james
the equipment i am using is a 7350 motion controller with a 4065 dmm module, attached is what i have so far.Efficiency Checker updated.vi
