asharma

I had previously posted my querry but as per suggestions i uploading new vi. To be precise what is required in this project is to create a counter and count the no of times an event occurs(which in this case is toggling of switch). This vi is simulation based because i dont have daq card at my home.(think of a daq instead of simulated signal) i would be grateful if anyone would help making a vi based on the objetive. The hardware model shows three holes and each has a bulb attached.When hardware switch is pressed a counter must start and count1=1,now if switch2 is pressed count2=1.again is switch1 is pressed count1=2, this process should go on. if anyone could build a vi with reference to above requirements using projectsimulate.vi as the base????

hello, this vi is not running..its logic as to what this vi will do can be understood from vi itself.

hello, this vi is not running..its logic as to what this vi will do can be understood from vi itself.

hello, this vi is not running..its logic as to what this vi will do can be understood from vi itself.

Hello , I am new to LAVA .I am making a project in LabVIEW which is a software made on parallel lines of DCS and SCADA.I have made a vi but it is not working as intended.The basic idea is to develop a software for accquiring real time signal from different units/hardware (As the photos mailed show). It is also required that on clicking a single print report button a report to printer must be sent from t=0 to t=T (The data must also get saved for future reference). I am posting photos of my hardware built.Now there are 3 voltage signals which are to be acccquired and when a hardware switch is toggled a counter should increment.(The procedure has to be done for three different sections).I tried doing this but was unable. I am mailing files that suggets all ways tried by me to do the above task. Three holes in hardware indicates three different voltage signals.a section is activated when a switch is toggled. Abhishek

Hello everybody, I am new to LAVA .I am making a project in LabVIEW which is a software made on parallel lines of DCS and SCADA.I have made a vi but it is not working as intended.The basic idea is to develop a software for accquiring real time signal from different units/hardware (As the photos mailed show). It is also required that on clicking a single print report button a report to printer must be sent from t=0 to t=T (The data must also get saved for future reference). I am posting photos of my hardware built.Now there are 3 voltage signals which are to be acccquired and when a hardware switch is toggled a counter should increment.(The procedure has to be done for three different sections).I tried doing this but was unable. I am mailing files that suggets all ways tried by me to do the above task. Three holes in hardware indicates three different voltage signals.a section is activated when a switch is toggled. Abhishek