asharma
-
Posts
6 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Gallery
Posts posted by asharma
-
-
hello,
this vi is not running..its logic as to what this vi will do can be understood from vi itself.
-
hello,
this vi is not running..its logic as to what this vi will do can be understood from vi itself.
-
hello,
this vi is not running..its logic as to what this vi will do can be understood from vi itself.
-
Hello ,
I am new to LAVA .I am making a project in LabVIEW which is a software made on parallel lines of DCS and SCADA.I have made a vi but it is not working as intended.The basic idea is to develop a software for accquiring real time signal from different units/hardware (As the photos mailed show). It is also required that on clicking a single print report button a report to printer must be sent from t=0 to t=T (The data must
also get saved for future reference).
I am posting photos of my hardware built.Now there are 3 voltage signals which are to be acccquired and when a hardware switch is toggled a counter should increment.(The procedure has to be done for three different sections).I tried doing this but was unable.
I am mailing files that suggets all ways tried by me to do the above task.
Three holes in hardware indicates three different voltage signals.a section is activated when a switch is toggled.
Abhishek
-
Hello everybody,
I am new to LAVA .I am making a project in LabVIEW which is a software made on parallel lines of DCS and SCADA.I have made a vi but it is not working as intended.The basic idea is to develop a software for accquiring real time signal from different units/hardware (As the photos mailed show). It is also required that on clicking a single print report button a report to printer must be sent from t=0 to t=T (The data must
also get saved for future reference).
I am posting photos of my hardware built.Now there are 3 voltage signals which are to be acccquired and when a hardware switch is toggled a counter should increment.(The procedure has to be done for three different sections).I tried doing this but was unable.
I am mailing files that suggets all ways tried by me to do the above task.
Three holes in hardware indicates three different voltage signals.a section is activated when a switch is toggled.
Abhishek
labview help9previously posted)
in LabVIEW General
Posted
I had previously posted my querry but as per suggestions i uploading new vi. To be precise what is required in this project is to create a counter and count the no of times an event occurs(which in this case is toggling of switch).
This vi is simulation based because i dont have daq card at my home.(think of a daq instead of simulated signal)
i would be grateful if anyone would help making a vi based on the objetive.
The hardware model shows three holes and each has a bulb attached.When hardware switch is pressed a counter must start and count1=1,now if switch2 is pressed count2=1.again is switch1 is pressed count1=2, this process should go on.
if anyone could build a vi with reference to above requirements using projectsimulate.vi as the base????