bipin Posted November 29, 2005 Report Share Posted November 29, 2005 Hi, Crio 9002 rt controller get disconnected in max. There is visa error which i realized later. The controller was working properly. I have tried formating the rt and installing software again. Bipin. Quote Link to comment
vijayasiva Posted November 30, 2005 Report Share Posted November 30, 2005 Hi Bipin, Is CRIO 9002 not detected in MAX and gives an visa error while programming? Can you explain the problem little clear.... vijayasiva Quote Link to comment
bipin Posted December 1, 2005 Author Report Share Posted December 1, 2005 Hi Vijay, The crio is detected in max but if i go to Labview and switch the target it does not switch. I tried pinging to the crio rtcontroller but it does not respond. When i go back to max i find a broken cross against crio. Now i restart crio it gets detected and if i do refresh in max sometime a broken cross appears else if i go to labview as i told earlier it will not switch. Actually this module was working properly. I had to change the rt startup program as i was making some change in the source code so i deleted the startup.exe from crio rt. After this i started facing this problem. Hope that the above info help, anyway have you faced similar problem earlier. Best Regards, Bipin Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.