IviScope with Agilent 54624A

[tabitz]

I am new to IVI drivers and am trying to control an Agilent 54624A with IviScope. I am able to initialize and configure channels/ timebase functions etc. but am having problems with initiating an aquisition and taking measurements. I have tried two methods: (1) running IviScope Initiate Aquisition and then IviScope Fetch Waveform and (2) IviScope Read Waveform. Both methods timeout and do not receive any data. Also, the scope is not taking a single aquistion like I would expect. It stays in run mode.

This is the software I have installed:

LabVIEW 8.0

IVI Compliance Package 2.3

ag5462x driver from NI site

Any ideas?

Tony