Jump to content

CAN Open interface to IFM I/O Modules

Pio

By Pio
in Hardware

Recommended Posts

Pio Newbie

Pio

Posted
Posted

Good afternoon everyone!

I have to set-up a CAN Open network based on IFM electronics (http://www.ifm-electronic.com) CR2033 I/O modules and a NI CAN PCMCIA card.

The problem, the big one, is that I never had used CAN bus... so, I'm studying...

Menawhile I set up the cablings and using the NI Canopen library I was able to send NMTs... the problem starts with PDOs and SDOs... that I'm not able to deal with succesfully.

Has someone used IFM modules with Labview?

Thanks in advance,

Pietro

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
Go to topic listing
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept