Hello.
Currently, I'm using LabVIEW ver. 7.1 and I want to do sme applications based on ADAM-4000 Series.
Now, here is my problem:
I've installed the software (LabView 7.1, the MAX that came with, the ADAM-4000 drivers, ADAM-4000-5000 Utility)
I've made a serial cable (RS232) because I'm using a RS232-485 converter. All the ADAM-4000 modules communicate on RS-485, so I needed that converter.
All were god till now.
I open the ADAM-4000-5000 Utility in order to set up the address of each module. They came from factory with the same address: 01. I needed to change it to see them all in that utility. Every module came with a CD included in its pack. The CD contains drivers, utility and some manual, but that is only generic, nothing I can use for my situation.
Here is the real problem: I cannot see my ADAM Module either in LabVIEW or in MAX.
The ADAM-4000-5000 Utility see all the module which are connected through the converter of course.
What shall I do? What did I missed? Is here someone can help me to solve this problem?
I'll be very thankfull for your help.
P.S.: The serial cable is fine and is configured as well. That's not the problem.