Hi,
Im quiet new in labview, using version 8.6.
I need to develop a system to detect a phase shift of vibration between a case and the rotor. (of a washmachine)
I simulated the signals in labview and the upper "pulse measurements.vi" quotes:
"Error -20308 occurred at an unidentified location
Possible reason(s):
Analysis: The waveform did not cross the mid reference level enough times to perform this measurement.
Check the signal length, reference levels, and ref level units.Analysis:
The waveform did not cross the mid reference level enough times to perform this measurement.
Check the signal length, reference levels, and ref level units."
If i attach a signal directly to the upper pulse measurement vi then it works fine.
if i run with the converted signal he gives the error, but i can continue
But i need to measure from 3Hz, now it's still 20
If i place it on 3Hz he refuses everything.
Hope someone know's a solution.
Download File:post-15503-1242203275.vi