yelingxing

A very strange problem happened to me recently. I have a subVI that I use as a result-monitor, and I have used it for a very long time. One day it stopped just after the other VI use it. I can see this subVI start to run, and then it stopped as if I pressed the Stop button, of course I didn't! Another day I used another VI by invoke node, and found the same problem. The VI ran and then stopped. I lighted both of the VIs and tried to see the data flow. The VI was started and none of the node was executed then the VI stopped. What happened to these VIs? I'm looking forward to the solution. Thanks.

I want to use NI VeriStand FPGA-Based I/O Interface Tools in my programme. The programme runs OK in LabVIEW and Iget the signal I want. However, when I integration into NI VeriStand and deploy it, it shows me an error. Actually my target is running normal. How can I solve this? The accessories are my programme and what is in NI VeriStand. Engine Simulation-Attempt-1.zip

I thought you have a dutiful IT. Have you asked IT if he modified your back up into old vision? Some webs always do this for one who use lower vision.