Dr Vipin Seetohul

Thanks indeed for the help. However i am still confused of how/where to connect the specific ports on the "write waveforms to file.vi". I have read and its quite obvious where to connect the 'error in', 'error out', and 'waveform' ports but what about 'file path', 'new file path', and 'append to file'. Do i just leave them? This is what error i get: --------------------------------------------------------------------------------------------------- Possible reason(s): Attempted to read samples that are no longer available. The requested sample was previously available, but has since been overwritten. Increasing the buffer size, reading the data more frequently, or specifying a fixed number of samples to read instead of reading all available samples might correct the problem. Property: RelativeTo Corresponding Value: Current Read Position Property: Offset Corresponding Value: 0 Task Name: _unnamedTask<88A> ----------------------------------------------------------------------------------------------------- I hope you can please help me out. Thanks. Vipin.

Hello! I have recently using LabView and am having lots of problem setting up a basic circuit (VI as is apparently called). Basically, i need to record the velocity of nerve signals over 10 channels and then save the data to disk(ASCII). How do we even create those channels? Do they have some sort of icons that we can add?? If i am posting in the wrong forum, can someone please advise me??? Thanks a lot. Relevant details - Using: LavView 7.1; DAQCard-6062E for PCMCIA; NI-DAQ Software; SHC68-68-EP Shielded Cable; CB-68LPR I/O connector block with right angled connector.