Karin Hellqvist

I got some help from NI Support who help me find the setting Minimum Edge Strength which I needed to lower to 20. This is due to my blurry image quality.

I think I maybe need to change my lightning to use from above instead of from below to get this improved. I know if I would like to grade according to the standards the lightning should be from above. Also my camera has manual focus and aperture, which makes it a bit hard to get better image quality.

ShaunR, thanks for your example. I saw that yo didn't manage to get the full size image down as you downloaded it. It should be 2391 x 2231 pixels. I tried your filter on my image with your values and some other values but didn't get it to work. 

Hi JKSH,

If you refer to the vertical bars the blurry edges is due to the printer printing the barcode. This is why I want to grade the barcodes. I have tried increasing the contrast in different ways.

Using downsampling I will find the barcodes, but looking at the image then the contrast is not better in that image.

In the attached image I have four Code 128 and two Code 39. I have problem detecting them without down sampling the image first. Since I want to grade the bar codes I don't want to down sample since the code quality is reduced then. I noticed this from that sometimes some of the bar codes are found without down sampling an then the grade is higher for those. Down sampling a factor 2 sometimes work, down sampling a factor 4 always works.

I have tried croping the image around the bar code but this doesn't help.

I'm using IMAQ Read Barcode 2, and have tried to change the parameter Min Bar Width with no result. Is there any other parameter I can change for the algorithm to find the barcodes, without having to down sample my image.

Best regards

Karin Hellqvist
Certified LabVIEW Architect

DVel