Hi RomainP,
Thank you very much for these drivers.
I am using them successfully with a FT232H (inside a UM232H module) and MPSSE-SPI running at 30Mbps to get familiar with the MPSSE operation via LabVIEW so I can communicate with PC via SPI slave device as you did.
I have a couple of questions I'm hoping you or someone can help with.
I am currently running a LV loop to write 50kbytes, then read 50kbytes to the SPI, at full speed...and this works... but it is half-duplex.
How would I go about implementing duplex..so I can have read & write simultaneously ? Is there a SPI read-write.vi ? Or could I perhaps write my own ?..if so could you make some suggestions...or is it not possible due to dll limitations ?
Secondly, are there some examples which show how to use the FT232H GPIO pins via LabVIEW whilst using your drivers ?
Regards,
tech1962