fra23 Posted April 12, 2011 Report Share Posted April 12, 2011 Hello everyone, I've been reading these forums and I finally decided to register. I am fairly new to LabVIEW (only been familiar with it for couple months now). I need to program a software for testing sensor voltage. So the sensor will be attached to the stepper motor and it will take measurements over the range of magnetic reading tracks. I finished programming the control of the stepper motor but now I'm on the data acquisition portion of the assignment and I am lost. I will be using a PXI-6224 NI card. Here are the requirements: - Acquire voltage amplitude of an analog sensor and wait 5 seconds after the movement and then measure - Measure the voltage over an adjustable time span and adjustable acquisition rate I need to use a TDM-file. Any help on how to get started would be greatly appreciated. Thanks. Quote Link to comment
Tim_S Posted April 12, 2011 Report Share Posted April 12, 2011 I need to use a TDM-file. Look through the examples that ship with LabVIEW for how to perform DAQ and writing a TDM/TDMS file. The examples are not full applications, but are quite good in showing how to do a specific task. Tim Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.