Jump to content

Recommended Posts

Hello

I have a cRIO-9066 and NI 9269 analog output c series module. I am running the cRIO in scan mode and I simulate a square wave using the simulation loop in labview which is the input for the analog output module (NI 9269). The frequency does not match but the amplitude matches. I have attached the simulation and timing parameters of the simulation loop. Does anyone know why there is a frequency mismatch? Thanks for the help.

Regards

Shravan

Simulation_parameters.png

Timing_parameters.png

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.