LabVIEW 8.0 HELP

[asharma]

Hello everybody,

I am new to LAVA .I am making a project in LabVIEW which is a software made on parallel lines of DCS and SCADA.I have made a vi but it is not working as intended.The basic idea is to develop a software for accquiring real time signal from different units/hardware (As the photos mailed show). It is also required that on clicking a single print report button a report to printer must be sent from t=0 to t=T (The data must

also get saved for future reference).

I am posting photos of my hardware built.Now there are 3 voltage signals which are to be acccquired and when a hardware switch is toggled a counter should increment.(The procedure has to be done for three different sections).I tried doing this but was unable.

I am mailing files that suggets all ways tried by me to do the above task.

Three holes in hardware indicates three different voltage signals.a section is activated when a switch is toggled.

Abhishek

[Tomi Maila]

This is a cross post, see another post in LabVIEW General thread.