Hi guys,
I have a problem with the crio-9073 and a stepper driver 9512, the status led starts flashing 4 times, that according to the manual is a memory usage issue, but I don't think that's the problem since I haven't run any program on it, It starts when following the tutorial to use hybrid mode, I have I/O cards under an fpga program and the stepper module (9512) in scan mode, when everything it's deploy and try to switch the target to active mode it says that the NI Softmotion didn't detect the module, I restart the target and then when loading the module (when the leds of the 9512 start to come up) the status led starts to flash 4 times.
I format the crio, install all the software (NI rio, softmotion, fpga, picture attach) and do the same tutorial,
http://digital.ni.com/public.nsf/allkb/12287236ED86B789862576630059572C?OpenDocument
and when the 9512 module leds start to pop up, the crio restarts and then the led status start to flash 4 times again.
I don't know if I'm doing something wrong here, but I really need your help with this.
Thanks in Advance
Javier Rocha