Jump to content

HELP ME


Ciro99

Recommended Posts

Hi everyone, I need help with a project where I have a LOGO! Siemens  6ED1052-1HB08-0BA0 
that communicates the states of inputs and outputs via Modbus/Ethernet with Labview, 
I wanted to ask you if it is possible, using labview to check the state of a Merker, 
then to virtually change the status of the Merker from 1 to 0. I have already tried Ethernet Modbus. 
thanks in advance for the help.

Link to comment
1 hour ago, Ciro99 said:

Hi everyone, I need help with a project where I have a LOGO! Siemens  6ED1052-1HB08-0BA0 
that communicates the states of inputs and outputs via Modbus/Ethernet with Labview, 
I wanted to ask you if it is possible, using labview to check the state of a Merker, 
then to virtually change the status of the Merker from 1 to 0. I have already tried Ethernet Modbus. 
thanks in advance for the help.

I cannot recall doing this with a LOGO! but have done it quite a bit with plain old S7s. The Modbus module (now open source) works just fine. What difficulties are you having?

Link to comment

Thanks for the reply. I am using Labview with the Modbus / ethernet module and can read the states of the inputs and outputs of LOGO! but I would also like to "write" them, such as changing the status of the Merker from 0 to 1. I don't know if I have made myself clear.

Link to comment

So I am not a Modbus expert, but have definitely written information to a PLC in the past. As far as I know you cannot write to input registers, I presume you can write to output registers (are they called coils?). I don't have the toolkits installed on my PC right now so I cannot check.

This code below works fine for setting Holding Registers. Have you tried writing to the Holding Registers? I

image.png.31a54c02261dcd7d4eeaca42796e8723.png

  • Like 1
Link to comment
22 hours ago, Neil Pate said:

So I am not a Modbus expert, but have definitely written information to a PLC in the past. As far as I know you cannot write to input registers, I presume you can write to output registers (are they called coils?). I don't have the toolkits installed on my PC right now so I cannot check.

This code below works fine for setting Holding Registers. Have you tried writing to the Holding Registers? I

image.png.31a54c02261dcd7d4eeaca42796e8723.png

Good morning, I'll try your advice. thank you very much for your reply.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.