digsey Posted November 8, 2008 Report Posted November 8, 2008 Hi! I am new to Labview (v.8.5). I have to create a program to control a HP8110A pulse generator with a GPIB interface. Are there any examples I can look at or anyone have any ideas where to begin and proceed? Only the basic learned.can use MAX to see it is connected,the instrument I/O and instrument driver but, to connect it and write the code is a bit of a problem It would be Very Much Appreciated!! Quote
crossrulz Posted November 8, 2008 Report Posted November 8, 2008 You can download drivers from the NI website. Try this link for your HP8110. If you don't like these, then you need to lookup the SCPI commands and create VIs that will build up the commands and send them over the GPIB bus. Quote
Neville D Posted November 8, 2008 Report Posted November 8, 2008 You can also download drivers for similar instruments from HP. The SCPI command set is fairly standard, and after confirming the command is the same, the driver should work. Neville. Quote
digsey Posted November 11, 2008 Author Report Posted November 11, 2008 Thanks lads.will take a look and see how i get on! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.