Jump to content
  • Similar Content

    • By Gan Uesli Starling
      So I have a multi-tab GUI. But for some reason, on load before run, it doesn't display the tab that was showing on save. It shows a tab which I don't want to be showing instead. On run, it starts with the right tab. Then saving and closing with that tab showing, on re-open (before run) it still shows a tab I don't want. How can I influence that?
      On top is the tab I want to show on open before run. At bottom is the tab that shows instead. You see my problem...


    • By piZviZ
      In my project i have 2 task
       
      (1).Read data of sensor (attached to arduino board) serially  and display on LabVIEW.
      (2).Control output(just ON-OFF) pins of arduino using LabVIEW.
       
       
      So,for that i am using TAB in labview.created 2 TAB called Oscillospe and Input.
       
      If i first start Oscilloscope it work well.
      But when i come to Oscilloscope tab after using Input tab.
       
      It gives Time out error (VISA read)
       
      If i am executing in Highlight mode it works well
       
      tab--event.vi
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.